10
11
5.0:
REVEAL 6 PERFORMANCE DATA
7.0:
SERVICING
7.1
:
CABINET FINISH
To remove marks and scuffs use a soft brush. If necessary, a little warm water and detergent can be used but under no
circumstances use a solvent or abrasive cleaner.
7.2:
DRIVER REMOVAL
Lay the cabinet on its back. Remove the ten hexagonal screws and set aside. Ease the driver from the front of the cabinet taking
care not to mark the front surface. Remove the driver, note the polarity of the internal connections and disconnect the internal
wiring. Take care not to damage the moving parts of the LF driver. To refit the driver, connect the cables from the crossover to
the LF terminals. Fit the driver into the mounting hole, making sure that the internal connecting cables are not trapped or able
to touch the LF cone. Fasten the screws finger tight and then progressively tighten them down with the appropriate Allen key.
Repeat the same procedure for the HF driver.
6.0:
REVEAL 6 TECHNICAL SPECIFICATIONS
Frequency response
(1)
Recommended amplifier power
Power handling
Nominal Impedance
Sensitivity SPL / 1 W @ 1 m
(3)
Distortion
Crossover frequency
Dispersion (@ -6dB)
Drive unit LF/MID
WideBand
™
HF
Shielded
LOUDSPEAKER
63Hz - 51kHz
50 to 100 W rms into 8
Ω
Average
(2)
50 W rms
Programme 100 W
6
Ω
90 dB
< 0.6%
2.9kHz
90 degrees
165mm (6") multi fibre paper pulp cone
25mm (1") titanium dome neodymium magnet system
Yes
Low frequency design
Cabinet construction
Cabinet finish
Fittings
Cabinet dimensions (HxWxD)
Total Cabinet weight
Shipping dimensions (HxWxD)
Shipping weight
CABINET
Optimised bass-reflex loaded
MDF cabinet and front baffle, Tongue and groove front and back
Maroon satin texture finish front, Grey vinyl sides and back
4 x M6 inserts for Omnimount
™
30 series bracketry
340mm (13
3
/
8
”) x 210mm (8
1
/
4
”) x 319mm (12
1
/
2
”)
7.8kg (17.16lbs)
622mm (24
1
/
2
”) x 287mm (11
1
/
4
”) x 440mm (17
3
/
8
”)
16 kg
(1)
+/- 3 dB, measured at 1m in an anechoic chamber.
(2)
Long term power handling capacity as defined in EIA standard RS426A.
(3)
Averaged over specified bandwidth for half-space environment.
Tannoy operates a policy of continuous research and development. The introduction of new materials or manufacturing methods will always equal or exceed the published specifications which Tannoy reserve the right to alter without
prior notice. Please verify the latest specifications when dealing with critical applications.
NOTES
