Tannoy IW60EFX, User Manual

Page: 6 / 12

5
INSTALLATION GUIDELINES
1. Fit the pre-install bracket frame to the 2ft x 4 ft
wooden studs by using suitable fixings (fixings
not supplied). See Fig 1
SAFETY NOTICE: The user is responsible for
fixing the hardware to the surface to ensure safe
operation.
2. Lay the cables
(i) Lay the loudspeaker cable from the amplifier
to the installed pre-mount frame. See point 5 for
connection instructions.
(ii) iw60EFX only : Note that the iw60EFX
features a 12V relay switch which allows the
speaker to toggle between “Cinema” and
“Music” modes if the AV receiver supports this
function. To use this facility you will need to lay
two-core loudspeaker cable from the AV receiver
to the first iw60EFX pre-mount frame then lay
loudspeaker cable from that location to the next
iw60EFX pre mount frame to allow daisy-
chaining. See point 6 for connection
instructions.
NOTE: The pre-install frame has four 21mm
diameter holes to accommodate cables or even
conduit, if required (two are positioned at the top
and at two are positioned at the bottom). These
holes are blocked off by grommets. Simply
knock out the appropriate grommets and pass
the cables or conduit through the appropriate
holes
3. Complete the wall, leaving the pre-install
frame exposed. See Fig 2
4. Connect the loudspeaker cables. The positive
terminal on the amplifier channel ( or
coloured red) must be connected to the positive
terminal on the loudspeaker (coloured red). The
negative terminal on the amplifier channel
(marked - or coloured black) must be connected
to the negative terminal on the loudspeaker
(coloured black). pre-install frame exposed. See
Fig 3
Fig 1.
Fig 2.
Fig 3.
definition inwall manualv2.qxd:Layout 1 25/10/07 11:30 Page 5