6
7.1 MECHANICAL INSTALLATION GUIDE FOR SUSPENDED CEILINGS
Slide the tile panel back into the suspended ceiling. The tile bridge ends will catch over
the railings, supporting the weight of the speaker.
5
Slide the speaker assembly through the hole and turn the screws on the front of the
speaker to extend the black mounting wings. Tighten the screws until a firm grip is
achieved.
4
DO NOT OVERTIGHTEN!
Place the C-ring and tile-bridge on top of the ceiling panel, aligning the C-ring over the
hole, and screw the C-ring to the tile bridge using the fixings provided.
3
Cut out the hole in the ceiling tile using a circular saw or pad saw.
2
Remove the ceiling tile from its frame and place it on a flat surface. Mark the
cut-out area on the ceiling tile by tracing around the template provided.
1
7.2 MECHANICAL INSTALLATION GUIDE FOR SHEET-ROCK (PLASTER BOARD) CEILINGS
Slide the speaker assembly through the hole then swivel the speaker to point in the
desired direction.
Tighten the black mounting wing screws until a firm grip is achieved. If using a power
driver, Tannoy recommends a torque setting of 1.5Nm.
DO NOT OVERTIGHTEN!
NOTE: When the screws are tightened the speaker will lock into position.
4
Go to section 6 for wiring and set-up instructions then return to point 4 below.
3
Cut out the hole in the ceiling using a circular saw or pad saw, then slide the
C-ring into the ceiling, aligning it over the cut-out hole).
2
Mark the cut-out area on the ceiling by tracing around the template provided.
1
7
Replace the front trim to conceal the mounting wing screws.
5
CMS
Swivel the speaker to point in the desired direction.
Tighten the black mounting wing screws until a firm grip is achieved. If using a power
driver, Tannoy recommends a torque setting of 1.5Nm.
DO NOT OVERTIGHTEN!
NOTE: When the screws are tightened the speaker will lock into position.
6
Summary of Contents for CMS 401e
Page 8: ...14 15 CMS NOTES NOTES ...
