6
7
Press ON/OFF to
turn off.
* When the registered weight is insufficient, “PC-25” is displayed. In that case, increase the
number of specimens to 25 pieces. When the stable mark is displayed, press CAL. If the register
is still insufficient, the display changes to show the number of specimens to be increased.
Therefore, increase the number of specimens, and press CAL again. This operation is repeated
until the registered weight becomes 1 g or more.
will be displayed when you press CAL if
the registered weight is too low to measure. Numeric numbers change as follows. (Press TARE
to increase the number of specimens)
10
→
25
→
50
→
100
→
150
→
200
→
250
→
500
11
PROGRAMMING AUTO POWER OFF
Default setting is 10 minutes
The auto power off time can be programmed between 0 (= no auto power off) to 60 minutes by
10 minutes increments according to preference.
◆
◆
Press CAL to display
.
When the power
is off
Press MODE to
confirm
While pressing
MODE press
ON/OFF.
50
60
20
10
0
40
30
Wen you have made
your selection, press
MODE to confirm.
The numeric values
are displayed.
Setting is finished.
Press TARE to cycle
through the time
options.
* If the power turns off before
appears, the setting is not saved.
1
2
3
4
5
6
7
8
PROGRAMMING BACKLIT BRIGHTNESS
Press CAL to display
.
When the power
is off
Press MODE to
confirm.
While pressing
MODE press
ON/OFF.
3
4
2
1
0
Wen you have made
your selection, press
MODE to confirm.
The numeric values
are displayed.
Setting is finished.
Press the TARE to
cycle through the
backlit options.
BATTERIES REPLACEMENT
When batteries are running low,
is displayed. When batteries are running out,
is
displayed and the power is automatically turned off.
Immediately replace with new batteries (all 4 batteries). Do not apply excessive force to the
measuring section when replacing batteries.
Default setting is “2”.
◆
1
2
3
4
5
6
7
8
TROUBLE SHOOTING
•
The power doesn’t turn on.
Insert new 4 size AA (LR6) batteries. Be sure that the polarity of the batteries is set properly.
•
or
appears on the display.
The scale needs to be repaired. Please contact your retailer.
