Medix 1700SF User’s manual
3
Electrical and Power Source
1. The Monitor display unit must operate on a power source as
shown on the specification label. If you are not sure what type of
power supply is used in the area, consult your dealer or local
power supplier.
2. The power cords must not be damaged. Applied pressure,
added heat, and tugging may damage the power cord.
3. The power cord must be routed properly during setup. This
precaution is needed to prevent people from stepping on the
cords or while the unit is suspended to prevent flying objects from
getting tangled with the unit.
4. Do not overload the AC outlets or extension cords. Electrical
shocks or fires may occur from overloading.
5. Do not touch the power source during a thunderstorm.
6. If your hands are wet, do not touch the plug.
7. Use your thumb and index finger, grip firmly on the power cord
to disconnect from the electrical socket. Pulling the power cord
may cause damage.
8. If the unit is not going to be in use for an extended period of
time, remember to disconnect the unit.
9. The Monitor display unit uses voltage between 90-264VAC.
Connect the unit to a power source with the same numerical
value. Please use only the power cord provided to ensure safety
and EMC compliance.
External Environment
1. Do not insert objects into the openings.
2. Do not allow liquids to seep into the internal areas of the
Monitor display unit.
3. Allowing liquids to seep in or inserting objects into the unit may
result in electric shocks and/or short circuit of the internal parts.
