15
OPERATION AND FUNCTIONS
DAB tuning
When the unit is turned on for the first time, all settings will be default settings. The settings can be
changed according to your preference. When the unit is turned off the next time, these settings will
naturally be saved as the new default settings. This also applies if you unplug the unit.
DAB/FM
4
3
2
1
AUTOTUNE
INFO
CONTROL/TUNING
PRESS TO SELECT
1
+
2
2
1
When the unit has been turned on, channels
must be saved. This is done by means of the
autotune function.
To use the autotune function through the front
panel controls, press the AUTOTUNE button
for two seconds. An international search will
be initiated.
You can also press the AUTOTUNE button on
the remote control for two seconds.
Note:
If the button is only pressed once, the unit will
once again search for the channels already
found.
The message SEARCHING will be shown at the
bottom of the display, and you will see a bar at the
top of the display that grows longer indicating how
far the tuning process has come. As it finds
channels, you will see a figure at the top line to
the right of the display that shows how many
channels have been found.
If no channels are found, you must check if the
antenna has been correctly connected. You can
do this by tuning in on a channel through manual
tuning on the FM band, and then press the INFO
button to display the signal bar and check the
signal strength (see the section on FM tuning)
DAB/FM
4
3
2
1
AUTOTUNE
INFO
000000000000000 10
searching
DAB/FM
4
3
2
1
AUTOTUNE
INFO
00000
Searching
DAB/FM
4
3
2
1
AUTOTUNE
INFO
CONTROL/TUNING
PRESS TO SELECT
1
+
If you want to save a channel under one of the
four presets, you must press down the button with
the number concerned for two seconds. When the
channel has been saved and you wish to listen to
that channel, press the button with the number
that you have saved the channel under. The
procedure is the same for both FM and DAB.
Channels that have not been saved can be
selected either by means of the SCROLL buttons
on the remote control or the CONTROL/TUNING
button on the front panel. Note that if the channel
is selected by means of the CONTROL/TUNING
button, you must confirm your choice by pressing
the adjusting button. This function can be
deactivated by pressing the button for two
seconds.
1
1
2
2
2
Saving and selecting channels
Summary of Contents for DAB-50
Page 1: ...Operation Manual DAB 50 DAB FM Tuner ...
Page 20: ...www com tangent audio ...