5
General Instructions
Valve Assembly
11. Replace no.
20
and no.
21
on both
side no.
15
and tighten bonnets
sufficiently to seat valve.
bonnet
12. Remove
packing nut/locknut
assembly
from both no.
20,21
.
13. Slip no.
22
over each no.
20,21
.
14.
Packing nut and locknut
should
be loosely assembled before replacing
into no.
20,21
. Hand-tighten
locknuts
only against no.
22
.
Do not use a
wrench.
20,21
15
packing nut
locknut
bonnet
22
15. Tighten
Packing nut
down
against
lock nut
using two wrenches.
Hold
lock nut
while rotating
packing
nut
.
16. Attach no.
29
to no.
20,21
and
place no.
33
in the appropriate no.
29
.
Place no.
32
into no.
33
and no.
29
,
then tighten.
29,32,33
17. Connect supply lines, turn on
water and check for leaks.
Note: It may become necessary to
tighten bonnets and packing nuts
to stop leakage from outlet or
around spindle assembly.
8. Reattach no.
9/11
to no.
4
, making
sure no.
6
is in place.
9. Tighten no.
7
with a wrench against
sink bottom.
10. Tighten bottom no.
16
on both
side no.
15
on underside of sink with
a wrench. Also, tighten no.
12
on
no.
15
assembly.
12
16
12
19
18
17
15
8
4
7
15
Note: When tightening no.
7
and
no.
16
, make sure that both no.
15
’s
are located at the same height
above sink level. Tighten no.
7
and
no.
16
before tightening no.
19
’s
3 1/2
