4
T&S
BRASS
Installation:
See separate installation instruction for
installation of no.
6
into deck.
1. Shut off water supply and drain lines.
Apply teflon tape or pipe joint
compound to threads on both ends of
no.
5
. Screw no.
5
into no.
6
and
tighten with no.
7
.
General Instructions
2. Remove no.
7
(do not
remove grease from
parts) and place no.
3
on top of no.
5
.
3. Screw no.
10
onto no.
3
and tighten with a
wrench.
Note: Before
tightening no.
9
.
Check position of
no.
1
. Handle
should face front
towards the
operator.
Note: Do not
adjust no.
8
in
no.
4
. If unit is
too high, a new,
shorter no.
5
pipe should be
ordered from
T&S.
4. For attachment of no.
2
and no.
3
.
Screw no.
9
onto threaded end of no.
3
and tighten with a wrench.
5. Turn on water supply and check for
leaks.
Optional Wall Bracket
Note: T&S highly recommends
installing a B-0109-01 Wall Bracket
with these Pre-Rinse Units (included
with the B-0114-01B and the B-2362
units). It must be ordered separately
with other models.
The B-109-01 Wall Bracket should be
installed after entire unit is assembled.
Fit bracket on no.
5
as high as possible.
Cut off any excess nipple as needed, and
mount to wall.
7
5
4
8
6
3
10
5
1
3
9
2
Nipple
Clamp
Screws
