Using the VCS
7
Other recommended configuration
We recommend that you now configure the following:
The system name of the VCS. This is used by the TANDBERG Management Suite (TMS) to
•
identify the system. This can be set from the
System administration
page on the web
interface (navigate to
System configuration > System
).
Automatic discovery. If you have multiple VCSs in the same network you may want to
•
disable automatic discovery on some of them. This can be set from the
H.323
page on the
web interface (navigate to
VCS configuration > Protocols > H.323
).
The DNS server address(es), if URI dialing or Fully Qualified Domain Names (FQDNs)
•
are to be used. This can be set from the
DNS
page on the web interface (navigate to
System configuration > DNS
).
Refer to the online help or the VCS Administrator Guide (available on the CD that was shipped
with your unit and from www.tandberg.com) for complete information on configuring these
and all other options available on your VCS.
Using the web interface
To use the web interface:
Open a browser window and in the address line type either:
1.
the IP address of the VCS
•
the FQDN of the VCS.
•
The
Login
page will appear.
Select
2.
Administrator Login
.
Enter a valid administrator
3.
username
and
password
and select
Login
.
You will be presented with the
Overview
page.
Refer to the online help or the VCS Administrator Guide for further information on the
configuration options available for each page of the VCS web interface.
Using the Command Line Interface (CLI)
The command line interface is available over SSH, Telnet and through the serial port.
To use the command line interface:
Start a SSH or Telnet session.
1.
Enter the IP address or FQDN of the VCS.
2.
Login with a username of
3.
admin
and your system password.
You will see a welcome message.
For a full list of CLI commands available on the VCS, see the Command Reference appendix of
the VCS Administrator Guide.