D 13373.08
NOVEMBER 2007
MPS
TANDBERG
MPS
ADMINISTRATOR GUIDE
Dial-In Numbers
The
Static Conferences
configuration allows the users to
define prefixes, ISDN numbers, E.164 Aliases, H.323 ID’s
and SIP URI’s for each conference on the MPS.
The number of conferences in the Static Conferences list
correspond to the number of conferences in the Overview >
MCU panel.
How to get access to a Static Conference
The conference must be created and started from the web
interface of the MPS.
The participants can access a Static Conference by dialling
a single number using the definitions in the Static Confer-
ences, like ISDN, E.164 Alias, H.323 ID and SIP URI as the
conference ID.
Waiting Room
When users dials into a conference which is not started the
users are placed in a virtual waiting room (put on hold) for a
predefined period of time until the conference starts.
The predefined period of time is defined in the
setting found under the Single Dial In Number
configuration.
Static Conferences
About
ISDN
The ISDN number must be a valid PRI num-
ber of the TANDBERG MPS at hand.
Static Conferences Menu
DID E.164 Alias Prefix
The prefix value to be used together with E.164 Alias
numbers. The prefix will be registered on the connected
Gatekeeper.
DID H.323 ID Prefix
The prefix value to be used together with H.323 ID numbers.
The prefix will be registered on the connected Gatekeeper.
(DID - Dial In Direct)
E.164 Aliases
The H.323 E.164 numeric alias for each
conference.
The TANDBERG MPS must be registered to
a Gatekeeper.
H.323 ID
The H.323 alphanumeric ID
for each conference.
The TANDBERG MPS must be
registered to a Gatekeeper.
SIP URI
The SIP alphanumeric URI for
each conference.
The TANDBERG MPS must be
connected to a SIP proxy.
Note that the DID H.323 ID Prefix and DID E.164 Alias
Prefix are only used for adding extra dial in numbers
for each conference.
126
Introduction
Quick
Setup
Using
the MPS
System
Status
System
Configuration
Installation
Gateway
Configuration
Technical
Descriptions
Appendices
Main
MCU
Configuration
