Tandberg Data
Installing Your Tandberg DLT VS160 Drive
2-8
Tandberg DLT VS160 Installation and Operations Manual
Note:
Figure 2-3 does not show a terminator because none of
the three drives are at the end of the SCSI bus.
Figure 2-4: Attach Terminator (if necessary), SCSI, and Power
Cables to your Drive
5.
Secure the SCSI cable connectors by tightening the screws
until snug.
Note:
If the supplied SCSI cable does not fit the connector on
your SCSI host adapter, you either have an incompatible SCSI
host adapter or you need to purchase a cable adapter. Contact
Tandberg or your SCSI host adapter manufacturer for
information.
6.
Make sure the power switch on the rear panel of your DLT
VS160 Tabletop Drive is in the OFF position. Attach the
female connector on the power cable to the power connector
on the rear panel of the drive.
Terminator
(or cable to
next SCSI
device)
DLT VS160 SCSI
Cable
To computer or
previous SCSI device
Power Cable
