Tandberg Data Storage Library T24, Installation Instructions Manual

Page: 2 / 8

2
OF
8
A
SSEMBLING THE
R
AILS
1. Measure the depth of your rack—Using a tape measure, measure the inside distance
from the front mounting holes of your rack to the back mounting holes.
2. Position the front and back sections of the left-side rail as shown in Figure 1 , with the
front rail section on top of the back rail section. Spread the sections to the distance you
measured in step 1.
3. Assemble the left rail using four M5 screws, as shown in Figure 1 . Keep the screws loose
so that you can adjust the length of the assembled rail, if necessary.
Warning
Before performing any installation or maintenance procedures, be sure
that the library power switch is in the off position and that the power
cord is disconnected from the library and the outlet.
Warnung
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu
achten, daß der Library-Netzschalter auf “Aus” gestellt ist und daß das
Anschlußkabel vom Library und der Steckdose entfernt ist.
Advertencia
Antes de realizar cualquier procedimiento de instalación o de manten-
imiento, comprobar que el interruptor de alimentación de la biblioteca
está apagado y que el cable de alimentación no está enchufado ni a la
biblioteca ni a la toma de corriente.
Figure 1 Assembling the left-side rail
Left-side rails (viewed from front)
Front
Back
Front
section
flange
section
M5 screw
(black)
Small back flange
(attach the library
here in final step)
Back flange