Tandberg Data Magnum 448, Manual, Page: 9 / 16

9
OF
16
Tape drive (FH configuration)—– Connect the supplied serial cable and the power cable to the tape drives.
Figure 10 Installing additional tape drives: full height serial connectors
Figure 11 Installing additional tape drives: full height power connectors
Connect bottom FH tape drive
to the
bottom internal library connector (Drive 1).
Connect top FH tape drive to
Library
FH tape drive
FH tape drive
the second internal library connector (Drive 2).
Serial cable connections
Full height configuration
Also see Figure 1 .
Drive 1
Drive 2
Top power connector
(not used in this configuration)
Second power conn
(not used in this configuration)
Bottom power connector
Third power connector
Your library has
either
a
Rev “A” or Rev “B” power
cable.
See Figure 3 .
FH tape drive
Tape drive
carrier
Power cable connections
Rev “A” power cable
Route the Rev “A” power
cable
through
tape drive
carriers, as shown here.
Last power connector
Middle power connector
(long cable)
Short cable–not used with
the full height configuration
Rev “B” power cable
Route the Rev “B” power
cable
outside
tape drive
carriers, as shown here.
Library
Library
Full height configuration
(long cable)