TX7211 Addressable Sounder Circuit Module
Installation & Operation Manual
4050100453-Rev1.1-1217
TANDA UK
Specifications are subject to change w ithout prior notice
5
2 Installation
2.1 Installation Preparation
This Addressable Sounder Circuit Module Unit must be installed, commissioned and maintained by a
qualified or factory trained service personnel. The installation must be installed in compliance with all
local codes having a jurisdiction in your area or BS 5839 Part 1 and EN54.
Tand products has available range of Addressable Sounder Circuit Module Unit, each Unit is
designed for specific application, it is essential to consider the requirement of both sides of the Unit
to avoid malfunction and typical fault scenario. The main caution is to ensure that the voltage rating
of the equipment and Unit are compatible.
2.2 Installation and Wiring
1.
Mount the Addressable Sounder Circuit Module Unit base on standard one [1] gang
electrical back box. Follow the arrow mark for the correct position. Do not over-tighten the
screws otherwise the base will twist. Use two M4 standard screws.
2.
Connect the wire in terminal according to the requirement as shown in Figure [2]. Verify the
device address and other parameters then stick on the label before attaching the Unit. The
sticker labels are available on the control panel. Align the Unit and tabs and gently pushing
the device until it locks into place.
Figure 1: Addressable Sounder Circuit Module
