Tanco Autowrap 1814, Operator'S Manual

Page: 26 / 146

Tanco Autowrap -
Operator’s Manual
25
Operator Setup Menu
The default settings for the machine are developed by Tanco for optimal operation of the machine. However, the operator can change certain parameters in the ‘Operator Setup’ menu to
take account of operational conditions.
1814 Operator Setup
Software rev. 049
Parameter Default Menu No. Description
Contrast FULL 4.01 Adjusts the display contrast
Film Break OFF 4.02 Set ‘ON’ to enable sensors on the film dispenser. This allows you to continue wrapping with only one dispenser when one runs out.
Remote type IR 4.41 Set to RF if you using Radio remote.
Continuous Off` 4.55 Set Off the controller will run Loading, Wrapping and Offloading as individual functions and stop when each is complete.
Set 'ON' the controller will run a complete continuous cycle, Loading, Wrapping and Unloading with just one button press, L5 button.
Squeeze in 0.0s 4.07 Set time period squeezing during auto load sequence.
Load up + 0.0s 4.08 Set load arm up time period past up sensor in auto load sequence.
Squeeze out 0.0s 4.09 Set time period grab open during auto load sequence.
Load down pause 0.0s 4.1 Set time period between grab open and load down during auto load sequence.
Load Down + 0.5s 4.53 Set load arm down time period past down sensor in auto load sequence
Load up delay 0.0s 4.54 Time period between squeeze and load arm up in auto load sequence.
Conveyor Down 0 4.14 If required you can set the conveyor to be slightly raised while wrapping (by adjusting the conveyor down sensor posn).
This sets the time period that it drops for during auto unload sequence
Pre-Rotate 0.0s 4.51 Tme period which the bale rotates on the table before wrapping so on rectangular bales the film is applied to the long sides of the bale first.
Stop bale pulse 1 4.22 Select the no of ½ turns of the wrap arm before the bale starts turning at the start of the wrap sequence.
Wraps to release 2 Pulses 4.23 Selects the no of wraps before it film is released by the Cut and start units.
Release 2 10 Pulses 4.24 Selects the no of wraps before the second film release by the Cut and start units.
Delay To Stop 0.0s 4.27 Selects the delay on the last rev before wrap stops (note: it will always reverse back till it sees the sensor).
Bale Unload 8 4.29 The time period the rollers turn to unload the bale from the Rocking rollers to the unload conveyor.
Conv. Level No 4.57 Set to No, the conveyor remains in the down for unloading. Set to Yes, the conveyor raises to receive the unloading bale.
Language English 4.35 Select the display language.
7. EH CONTROLLER INFORMATION