www.tanakapowerequipment.com
1
Owner’s Manual
TPS-200
1. Introduction
It is important that you read and understand your TANAKA brush cutter owner's manual as well as this manual. Please
carefully review and observe all safety precautions and warnings. Careless or improper use of the unit may cause serious
or fatal injuries.
This pole saw attachment has been designed for certain TANAKA brush cutters.
SAFE OPERATION
WARNING
DANGER
All overhead electrical conductors and communications wires can have electricity flow with high voltages. Never touch
wires directly or indirectly when pruning, otherwise serious injury or death may result.
•
Review the area to be trimmed. Look for hazards that could contribute to unsafe conditions. DO NOT operate unit
if any wires(power, telephone, cable, etc.) are closer than 15M (50ft.) to any part of the operator or
•
unit.(Fig. 1 -1)
•
Spectator and fellow workers must be warned, and children and animals prevented from coming nearer than 15M
(50ft.) while the pole saw is in use. (Fig. 1 -2)
•
Avoid all power lines. This unit is not insulated against electrical current.
•
Always wear head protection with full face shield to help protect against falling branches and debris. (Fig. 1 -2)
2. Assembly procedures
Installation of cutting attachment -
1. Remove angle transmission from your brush cutter.
2. Join the attachment in place of it. (Fig. 2-1)
NOTE!
If your brush cutter tube is 26mm diameter, remove bracket collar B (4) by pulling the lock pin (1).
3. Make sure the lock pin (1) fits in the location hole (2) of tube and that the tube will not come off. (Fig. 2-2)
4. Tighten the knob nut (3) securely. (Fig.2-2)
WARNING!
Never try to start engine without side case securely fastened.
