3
There are two alarm functions.
1.
Timer with clock alarm
a.
Press the Alarm button on the rear of the receiver to activate or close the alarm and to see the previously set time. Blue button on the
right on the rear of the receiver. Setting can be seen on the screen. To set the alarm time: press the blue button for 2 seconds, press UP or
DOWN to set the time. Setting can be seen on the screen.
2.
Temperature alarm
a.
Press DOWN to change between Celsius and Fahrenheit. Check on the screen.
b.
Press DOWN for 3 seconds to open the setting mode.
c.
Press UP / DOWN to activate or close the alarm. (It is the temperature of the sensor that is measured) ON or OFF setting can be seen on
the lower half of the screen.
d.
Press SET / UP / DOWN to set the desired high and low temperatures for example high 54
°
C and low 0
°
C.
e.
Once the desired temperature is reached, the alarm will ring for a short time and the sensors’ temperature reading on the screen will
blink.
f.
Press Down for 3 seconds to open the setting mode, then UP / DOWN to switch the alarm off, press SET to finish.
We recommend that the surrounding temperature is 20
°
C or above before using the Heat Pro Chamber.
Note: The Hygro-thermometer also measures the relative humidity of the air in %RH; (Can be seen on the right of the screen) and has a low temperature
alarm. These functions are not in use with insect treatments
T
A
N
A
C
O
A/
S a
P
els
is
G
rou
p
Co
m
p
a
ny
–
G
le
nt
e
vej
1
1
–
670
0 Es
b
je
rg
Ø
–
Den
m
a
rk
–
T
e
l. +
45
75
1
4
48
00
–
w
w
w
.t
a
na
c
o.c
om
