tams elektronik MT-1, Manual, Page: 8 / 36

tams elektronik
English MT-1 | MT-2 | MT-3
too much) solder simultaneously. As soon as the solder begins to
flow, remove it from the soldering point. Then wait a moment for the
solder to flow well before removing the soldering iron from the
soldering joint.

Do not move the component you have just soldered for about 5
seconds.

A clean, non-oxidised (scale-free) soldering tip is essential for a
perfect soldering joint and good soldering. Therefore, before each
soldering, wipe off excess solder and dirt with a damp sponge, a
thick damp cloth or a silicone wiper.

After soldering, cut off the connecting wires directly above the
soldering point with a side cutter.

After assembly, always check each circuit again to ensure that all
components are correctly inserted and polarised. Also check that no
connections or tracks have been accidentally bridged with tin. This
can lead not only to malfunction, but also to the destruction of
expensive components. You can re-liquefy excess solder with the
clean hot soldering tip. The solder then flows from the board to the
soldering tip.
Seite 8