tams elektronik
!
English
WD-34.BiDiB | WD-34.M.BiDiB
7. Check list for troubleshooting
Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: One or several connections are faulty.
à
Check the
connections. If the in- or outputs of the decoder have been
connected to live cables the decoder usually is damaged beyond
repair.
The decoder is not displayed by the control software (the node has
not been identified).
Possible cause: The patch cable(s) is/are incorrectly inserted into the
connection sockets or is/are defective.
à
Check the cable(s) and the
connection(s).
Possible cause: The interface´s connection is faulty or the interface
is defective.
à
Check the interface and the connections. Check
whether other nodes connected to this interface are also not
displayed.
Connected accessories do not switch.
Possible cause: The decoder´s connection to the power supply has
been interrupted.
à
Check the connections.
Possible cause: The decoder´s connections to the accessory(s) have
been interrupted
à
Check the connections.
Possible cause: The accessory is defective.
à
Check the accessory.
Page 24