English
LD-G-14
Page 36
Speed level
The decoder can drive 27 speed levels. Driving all 27 speed levels can
be done only with central units which support this mode (e.g.
MasterControl). With central units which only allow 14 speed levels
only, it is only possible to select every second speed level.
Velocity characteristic
The decoder can be adjusted to the individual
driving characteristics of the motor and the
characteristic speed of the locomotive type, by
setting the starting velocity and the maximum
velocity. From the starting velocity and the
maximum velocity the decoder generates a
velocity characteristic corresponding to the
opposite figure. This characteristic allows a
good fine tuning of the speed in the lower
speed range.
Shunting gear
The auxiliary function F4 allows you to switch into the shunting gear
mode. In the shunting gear mode the velocity of all speed levels is
reduced to ca. 25 % compared to the standard velocity.
Acceleration and brake delay
It is possible to program the acceleration and brake delay individually.
You can switch the acceleration and the brake delay on or off by
operating the function key F3. Even if the acceleration and the brake
delay are active you can actuate an emergency stop via the central unit
by reversing the direction of travel.
Function outputs
The decoder has four function outputs which can be switched on and
off via the function keys „function“ and / or the auxiliary function keys
F1 to F4. They are available to connect optional accessories (e.g.
lighting, smoke generator, sound module, electric coupling).
x = speed grade
y = motor voltage
