TCC-1200 OPERATION MANUAL
Ⅰ
.MACHINE SPECIFICATIONS
：
(1) POWER REQUIREMENT
：
220V/50HZ
(2) RATED CURRENT
：
12A~14A
(3) CONSUMPTION POWER
：
3000W
Ⅱ
.FUNCTIONS AND OPERATION INSTRUCTIONS
(1)
HOT LAMINATION
：
a. Use hot laminating film, Feed the film onto the rods as
picture (A).
b. Turn on the machine. The power switch and the control
panel will light up.
c. Determine the correct temperature setting for your
film. The table below gives the suggested
temperature/speed settings:
FILM
THICKNESS
TEMPERATURE SPEED
38
μ
105
O
C
3
75μ
110
O
C
2
100μ
115
O
C
2
125
μ
125
O
C
2
d. Press the “HOT” key for heating and the “HEATER” light
will turn red.
e. The machine will beep before it reaches the set
temperature of 3
o
C and the “READY” light will turn on.
Wait another 10~12 minutes before laminating.
f. Pressure adjustment
：
Turn the handle wheel downward to increase pressure
and make the top and bottom rollers close tightly.
g. After finishing hot lamination you can turn off the
machine by pressing the “COLD” key and the “HEATER”
light will turn off. Wait until it reaches 50
O
C before
shutting down the machine.
