Electrical:
Voltage
Power
Air Flow
Operation
Insulation Value of
Closed Doors
Weights
Top Housing
Lower Housing
115 VAC 60Hz
(High Speed) 450 Watts
(Low Speed) 340 Watts
High Speed 3400 CFM
Low Speed 1900 CFM
30 second Door Cycle Time
(Open-Close)
Model:Ghost R-38
Model:Ghost/R50 R-50
Whole House Ventilator: 48 Lbs.
Shipping: 71 Lbs. (2 boxes)
26 1/4” L x 26” W x 14 1/8” H
25 7/8” L x 29 1/2” W
x 13 5/8” H
specificationS
GHOST-Optional wiring
for fan operation
(control not included)
WARNINGS:
State and local
electrical codes may require that
the GHOST be installed
by a licensed electrician.
Check with your local code
officials before installing.
The GHOST is not for use
with solid state controls.
Be sure to turn off power
before wiring the GHOST.
Figure 6.
Figure 7.
6. Rotate the upper housing until it lines up with the
lower housing. Make sure the edges of the two hous-
ings mate all the way around the GHOST (Figure 6)
and then pull the black attachment handles down over
their attachment posts (Figure 7).
7. If desired, secure the GHOST to the top of the joists.
8. Plug the connector from the GHOST into the Control
Box. Plug the Control Box into an unswitched,
grounded receptacle.
9. Install the ceiling grille (screws provided).
10. Check the unit for proper operation.
Operating your GHOST
Important
- Be sure at least one window is open when the
fan is operating. The GHOST is controlled by the hand held
remote transmitter. The transmitter has two buttons; ON/OFF
and LO/HI. LO/HI controls the speed of the fan. See the
Wiring section of this manual for further details.
The line cord must
remain plugged into
a constant HOT outlet.
Hardwiring the unit to controls using the YELLOW, BLACK and
BLUE wires will allow for additional, manual operation. Use of
controls will override remote control functions. Recommended
controls are SPST switches and/or non digital spring wound
timers. Use of other controls will void the warranty.
