Installation Manual
Horizontal
Pole Mount
6
K.
Loosen the mid clamp, move to fit against the module and re tighten to hold position.
L.
Install mid clamp top with the 1/4 x 2.5 hex bolts, flat & lock washers and torque to 7ft Lbs.
M.
Repeat until last module is ready, then add the last end clamp base 1/4" wider than the module
width, place the module onto the clamps, center the module, move end clamp base up against the
module, attach last mid clamp top and under module clamps as done in previous steps.
Step 4: Set final angle
A.
Loosen all the U-Bolt nuts on the end and mid clamps just enough to allow the entire array
to be rotated to the desired angle to the sun, torque all the 3/8 U-Bolt nuts to 20ft Lbs.
