Check the LEDs on the RJ45 socket of IP Camera. If connection is ok, the green LED
turns on. If there’s any active data transportation, the orange LED will flash.
The LCD panel of IP Camera will show IP Camera’s current IP address/Network
Mask/Gateway.
IP Camera is available for visiting now. You have two methods to visit its homepage:
1
）
Run IPCamSearch Tool in the CD. This software will search for all IP Cameras in
your LAN. Select one and then click [visit] to continue.
2
）
Run an Internet Explorer, and input the IP address as shown on the LCD to IE’s
address bar, for example: http://192.168.0.234.
Note:
IP Camera by default use fixed (static) IP address setting. The default
IP address is :192.168.0.234, Network Mask is 255.255.255.0, Gateway is
192.168.0.1
4.3 Use IPCamSearch Tool to setup IP Cameras
Put the supplied CD into your CDROM, Click and run IPCamSearch.exe Tool.
Figure 14 IP Camera Search Tool
This tool shows all IP Cameras found on your LAN with its Serial Number/IP
Address/Firmware Version. If your IP Camera’s IP address is not as the same segment
of your PC(defined by IP Address and Network Mask), you may not be able to visit your
IP Camera. For example, Your PC’s IP address is 192.168.100.33, network mask is
255.255.255.0, then your PC will only reach IP address 192.168.100.1 to
192.168.100.255, If your IP Camera’s IP Address is not within this range, you cannot
- 12 -
