Tally T3016, Maintenance Manual

Page: 69 / 74

10 Cutting Device (Option)
Safety notes:
– If you have any short pieces of paper remaining in the device, turn off the printer
first.
– Do not stick unsuitable materials or tools – such as screw drivers etc. – into the
device openings as this may damage the mechanical system.
– Replace the protective cap for the drive wheel at the printer when the cutter is no
longer needed (in use) to prevent long hair, chains etc. from being pulled into the
printer.
10.1
Specifications
Cut width 400 mm
Print width 320 mm
Cut height min. form length 2.5 inches (6.35 cm)
Cut time
Printer/Cutter 1000 ms
±
10%
Specification of
recommende forms Only continous forms in printer tractors can be cut
Cutting accuracy Standard forms
±
1 mm
Other forms
±
2 mm
depending on the stiffness of the cross perforation
Cut device activation manually via the control panel, setting via the Setup Menu,
via interface
Service life 1.000.000 cuts
Weight approx. 4 kg
Paper type only fanfold paper can be cut
Paper weight 60 g/m
2
– 120 g/m
2
Stacker >150 sheets 80 g/m
2
For all further data and specifications, please refer to your printer’s standard
operator’s manual or the operator’s manual “Cutting Device”.
Specifications Cutting Device (Option)
10-1