VIP3000 Visually Impaired Programmable Thermostat / Customer Information
10
To adjust the DAY time period settings follow the same procedure, as you did for
WAKE time. EVENING and SLEEP then follow and are adjusted the same way.
When all four time periods are programmed, you’ll hear,
“Program Completed”.
To change the Saturday and Sunday program settings, press the upper
WEEKEND
button and follow the same procedure as you did for
WEEKDAY
.
If during programming set up you want to exit without accepting any changes you
just made to the settings, just briefly press the
RESET
button.
Now that we’ve gone through everything it’s a great idea to practice using the
thermostat. A good place to start is by actually changing the Programmable
Operation settings to your own time and temperature preferences. Don’t be afraid to
make changes. You can’t break it and any errors can easily be corrected!
Time Saving Tip:
To accept the current time period settings without making
changes, just press the
NO
button when you hear, “
Press the UP or DOWN key to set
minutes. When finished, press RUN”
.
You’ll then advance to the next time period
.
Pressing
NO
allows you to skip through time periods and is especially useful for
reviewing your current settings or for quickly changing just a few settings.
SECTION 4: DAILY OPERATION
Manual Operation
Press the
PROG
button until you hear “
Program is OFF
”.
Press the
SYSTEM
button to hear the system setting you want to run. When you
hear
“COOL”,
you're set to run in air conditioning. When you hear
“HEAT”,
you're
set to run in heating. If you hear,
“AUTO”,
you're in auto change-over, and you'll run
in either air conditioning or heating, depending on the current indoor temperature.
Please note if auto change-
over has not been set up, you will not hear “
AUTO
”. For
auto change-over set up information, refer
to “AC” in the table on page 15 of the
“VT3000 User’s Guide”.
“
Auxiliary”
is heard only if you have a heat pump system
and is used when emergency heat is required. When in emergency heat, the heat
pump is disabled and just your back up furnace operates.
Briefly press the
UP
or
DOWN
button to change the indoor temperature setting.
Each press will change the
HEAT
or
COOL
temperature setting one degree. The
temperature will stay at that setting until the
UP
or
DOWN
button is again pressed.
