AOR Series Analog Stations
Installation & Operation Manual
Page
11
of
27
Rev. 1/7/2022
Copyright 2021-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Accessing Programming Mode
The AOR Series Analog Station can be programmed from a standard touch-tone telephone through an
analog PBX extension or an analog PSTN line.
It is essential to program at least one telephone number for the Talkaphone unit to operate.
After entering the access code, the order in which codes are entered is irrelevant.
1.
Using the Security Code
1.
Mode Configuration DIP Switch #2
is configured at the factory to be in the
ON
position
—
this configures the call station to answer incoming calls. Move to the
ON
position if that is not
the case.
2. Call into the AOR Series Analog Station.
3. Enter the default security code:
827827
(or
TAPTAP
)
4. The call station will output a double-beep and enter programming mode
—any programming
code(s) may now be entered. See
Section 6.4, p.13
programming codes.
5. When programming is completed, enter this code to disconnect:
# 7
2.
Without Using the Security Code
1.
Mode Configuration DIP Switch #2
is configured at the factory to be in the
ON
position
—
this configures the call station to answer incoming calls. Move to the
ON
position if that is not
the case.
2. Move
Mode Configuration DIP Switch #3
to the
OFF
position
—this configures the call
station to answer incoming calls and automatically enter programming mode without the
security code.
3. Call into the AOR Series Analog Station.
4. When the call station answers, it will output a double-beep and automatically enter
programming mode
—any programming code(s) may now be entered. See
Section 6.4, p.13
for a comprehensive list of programming codes.
5. When programming is completed, enter this code to disconnect:
# 7
6. Finally, return
Mode Configuration DIP Switch #3
to the
ON
position.
NOTE:
After each programming code, a double-beep indicates the code has been accepted. Four (4) beeps
indicate an error
—re-enter the code again.
NOTE:
If
Mode Configuration
DIP Switch #3
is not returned to the
ON
position, activating the pushbutton
will call Talkaphone Technical Support instead of the programmed phone number(s).
