AOR Series Analog Stations
Installation & Operation Manual
Page
15
of
27
Rev. 1/7/2022
Copyright 2021-2022 Talk-A-Phone, LLC
• 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • [email protected] • www.talkaphone.com.
All prices and specifications are subject to change without notice. Talk-A-Phone, Talkaphone, bAlert, Scream Alert, WEBS, and WEBS Contact are registered trademarks of Talk-A-Phone,
LLC. All rights reserved. All other trademarks mentioned in this document or website are the property of their respective owners and does not imply or indicate any approval, endorsement,
sponsorship, or affiliation with such owners unless such approval, endorsement, sponsorship, or affiliation is expressly indicated.
Timing/Dialing Codes
The timing/dialing code is comprised of six (6) digits in the following format
—parameters A through F
are defined in the table below:
A B C D E F # 1 8
The factory default timing/dialing code is:
2 3 4 7 2 1 # 1 8
Parameter
Function Description
Values
Definition
A
Talk/Listen Delay.
Switching
time between talk and listen
modes (i.e. VOX switching time).
1
0.1 seconds
2
0.2 seconds
[Default]
3
0.3 seconds
4
0.4 seconds
5
0.5 seconds
6
0.6 seconds
7
0.7 seconds
8
0.8 seconds
9
0.9 seconds
B
Call Length.
Sets maximum
length of time the AOR Series
Analog Station can be
connected to a call.
When disabled, a CPC (Calling
Party Control) disconnect pulse
(voltage drop at end of call),
busy signal, silence, or return to
dial tone will be required for
proper hang up.
0
Disabled
1
1 minute
2
2 minutes
3
3 minutes
[Default]
4
4 minutes
5
5 minutes
6
6 minutes
7
7 minutes
8
8 minutes
9
9 minutes
C
Silence Time Out.
Sets the
length of time a call will be
connected without any voice
transmission.
0
Disabled
1
10 seconds
2
20 seconds
3
30 seconds
4
40 seconds
[Default]
5
50 seconds
6
60 seconds
7
70 seconds
8
80 seconds
9
90 seconds
D
Dial Next Number Timer.
Sets
the number of rings before the
AOR Series Analog Station dials
the next phone number in the
number list.
0
or
1
Disabled
2, 3, 4, … , 9
Dials next number after 2, 3, 4, … , 9
rings
[Default 7 rings]
E
Dial Next Number on Busy.
When a busy is detected the
AOR Series Analog Station will
dial the next phone number in
the number list.
1
Disabled
2
Enabled
[Default]
F
Not Used
Always set to
1
.
-
