Talet Equipment Mini Auger Bucket, Parts And Operation Manual

Page: 13 / 18

Mounting Instructions
Installation Instructions
After determining the rated capacity of your loader and adding any
counterweight kits that are needed you are ready to install your bucket.
1. Remove the chutes and hydraulic hoses from inside of the auger bucket.
2. Remove dust plugs from the auger motor.
3. Locate the fittings from the chute box and install them into the motor. Do not
allow dirt or contaminants to get into the hydraulic system (motor, hoses or
fittings).
4. Tighten the fittings into the motor and install the hydraulic hoses provided.
5. Install the bucket by following your skid-steer operators manual for installing
an attachment. Be sure to lock the bucket to the skid-steer.
Note: Keep in mind that the buckets are manufactured with two mounts, one on
each side of the bucket to allow for right or left discharge.
To avoid serious personal injury make sure the bucket is securely latched to
the skid-steer toolbar. Failure to do so could result in seperation of the bucket
from the skid-steer.
6. Connect the bucket's hydraulic hoses to the machines auxiliary hydraulics
using the quick couplers.
7. Turn the auxiliary hydraulics to the forward or locking position and the auger
should rotate so that the material in the auger bucket is discharged through the
casing at the discharge end of the auger bucket. If the material runs back up into
the bucket instead or discharging, reverse the hoses at the motor end.
Note: It is recommended to coat the bucket with a water-based releasing agent
such as Kleen Kote before using. Contact your local concrete supply center for
more information.
8. Install chutes to the discharge end of your auger bucket.
Do not coat bucket with any petroleum based agent. Damage to rubber
components will occur.