Fig. 1
Fig. 2
Fig. 1
BLADE HOUSING REMOVAL
& MAINTENANCE AFTER EACH USE
HOW TO DISINFECT
IMPORTANT!
1- With the Hair Plate in the open
position and the Clear Window removed,
hold by the Motor Housing (Middle
Section) with one hand while with the
other hand hold the Blade Housing and
gently open one side and then pull from
each other until Blade Housing is fully
detached just as shown on Fig. 1 and 2.
2- Now that you have detached the
Blade Housing from the main unit (See
Fig. 2), clean it, disinfect it and install it
back together when finished. Apply a
single drop of clipper oil (or 3-in-1 Oil) to
each sides of the blades. Turn ON the
unit for few seconds and now you can
stored it.
1- You can disinfect your Split-Ender
PRO2 every time you use it. You can use
S p r a y D i s i n f e c t a n t . F o l l o w t h e i r
i n s t r u c t i o n s . B a s e d o n n o r m a l
procedures you should always clean all
parts free of hair before you apply any
disinfectant to them. Leave it on for at
least 10 minutes before it is ready to use
again. (See Fig. 1)
12
