Takuma eTow, User Manual

Page: 23 / 25

43
/
46
EN
42
/
46
7. AFTER USE
Maintain your eTow after each use:
The eTow needs to be checked regularly and maintained to ensure
good working order and to reduce the risks of degradation.
Always flush the pump holes to clear of any sand, rocks, debris that
can damage the components.
Never allow sand and/or seawater to get in the connectors or it
may cause significant damage.
Always make sure the connectors are clean and dry and apply a
thin layer of connector grease regularly.
Check your eTow thoroughly after each use to make sure everything
is OK (screws, cover, etc.)
Only pack your eTow away after it is completely dry. Before storage,
always check that it is completely dry.
If needed, contact your TAKUMA authorized dealer for assistance.
After each use, rinse your eTow: Rinse the outside and inside with fresh water
without disconnecting the cables.
Dry the inside of the with a clean dry cloth until there is no sign of water left.
Also dry the ESC, battery and connector caps.
If the connectors get wet, rinse them with clean fresh water, then use a canister
of compressed air to blow out the water. Once its completely dry, apply a thin
layer of connector grease such as dielectric grease or NyoGel®.
Once the connector caps are dry, screw them directly back onto the connectors.
Remove the battery. Dry it completely and store it in a dry place.
Flush water spouts on each side of hull after ever use.
Open the hull drain plug when you rinse the inside with fresh water.