TAKIMA tools TKBG-150, Instruction Manual

Page: 4 / 16

3
ADDITIONAL SAFETY RULES
. Wear hearing protection during extended
periods of operation.
2. Use only wheels having a maximum
operating speed at least as high as "No Load
RPM" marked on the tool's nameplate. Use
only fiberglass-reinforced cut-off wheels.
3. Check the wheel carefully for cracks or
damage before operation. Replace cracked or
damaged wheel immediately.
4. Secure the wheel carefully.
5. Use only flanges specified for this tool.
6. Be careful not to damage the spindle,
flanges (especially the installing suface) or bolt,
or the wheel itself might break.
7. Keep guards in place and in working order.
8. Hold the handle firmly.
9. Keep hands away from rotating parts.
0. Make sure the wheel is not contacting the
workpiece before the switch is turned on.
. Before using the tool on an actual
workpiece, let it simply run for several minutes
first. Watch for flutter or excessive vibration
that might be caused by poor installation or a
poorly balanced wheel.
12. Watch out for flying sparks when operating.
They can cause injury or ignite combustible
materials.
3. Remove material or debris from the area
that might be ignited by sparks. Be sure that
others are not in the path of the sparks. Keep
a proper, charged fire extinguisher closely
available.
4. Use the cutting edge of the wheel only.
Never use side surface.
5. Do not attempt to keep the trigger in the
ON position.
6. If the wheel stops during the operation,
makes an odd noise or begins to vibrate,
switch off the tool immediately.
7. Always switch off and wait for the wheel
to come to a complete stop before removing,
securing workpiece, working vise, changing
work position, angle or the wheel itself.
8. Do not touch the workpiece immediately
after operation; it is extremely hot and could
burn your skin.
9. Store wheels in a dry location only.
SAVE THESE INSTRUCTIONS.