Loosen
Tighten
180
°
variable
Mounting
Hole
83.5
Hole for
Vinyl Tie
N・O
N・C
COM.
Blue
Black
Red
Yellow
White
Dry contact
relay output
1c
30V, 0.5A
Power
10.5V-30V DC
(non-polarity)
Mounting Base
Grip Bolt
Mounting Box
Ball Lock
Sensitivity
Volume
(Set at factory)
Operation LED
Mounting Base
1
PARTS DESCRIPTION
2
WIRING
3
INSTALLATION
4
ANGLE ADJUSTMENT
PASSIVE INFRARED SENSOR
PA-15WE (Wide angle, 15m)
PA- 30NE (Long range, 30m)
Instruction Manual
Thank you for purchasing this TAKEX passive infrared sensor.
This sensor will provide long and dependable service when properly installed.
Please read this Instruction Manual carefully for correct and effective use.
Please note :
This sensor is designed to detect passing objects and to initiate a signal ; it is not a burglary-preventing device.
TAKEX is not responsible for damage or losses caused by accident, theft, Acts of God (including lightning),
abuse, misuse, abnormal usage, faulty installation or improper maintenance.
DO'S AND DON'T'S
・
Install the sensor in such a direction that people are
more likely to cross the detection zones.
・
Do not install in a site which is directly by an air
conditioning exhaust vent.
・
Avoid direct sun light shining on the window of the
sensor.
・
Do not install in a site which is subject to electrical
noise.
・
Install sensor with its sensitivity volume downward.
HOW TO INSTALL
Install Mounting Box.
Break knockouts
(mounting holes) from
inside with a screw
driver, etc.
Tighten screws
provided.
Refer to 4. ANGLE ADJUSTMENT
and adjust the angle of the sensor.
Plug unused screw holes on
Mounting Base with push rivets
provided.
Attach Sensor Unit to
Mounting box with
screws provided.
You can install the
sensor to standard
single gang electrical
box (pitch : 83.5 or
66.7mm) available in
the market.
Refer to 2. WIRING
and connect wires.
Tie up wires inside the
box with a vinyl tie
provided.
(1)
(2)
(3)
(4)
(5)
Wire through the lower wire lead access on
Mounting Box to prevent water leakage.
NOTE :
・
Loosen the Grip bolt and ball lock
before adjusting to the required
angle.
After angle adjustment, tighten
them.
・
Do not fail to set Sensor Unit to a
lower angle than horizontal.
2.62”
3.29” 83.5
66.7
180°
movable
180°
movable
Ball lock
Grip bolt
90°
movable
The direction of rotation of the left and right grip bolts is the same.
Please do not rotate each in the opposite direction.
Please refer to the direction of rotation described on the body
sticker.
Accessories
Tapping screw
φ
6
×
30 (4 pcs.)
Tapping screw
φ
4
×
8 (1 pc.)
Combining band
(1 pc.)
Instruction manual
