Takeuchi TB28FR, Operator'S Manual

Page: 71 / 182

69
OPERATION
Machine Operation
Inspection After Warm-up
After warming up the engine and hydraulic
oil, perform the checks and inspections
described below, and repair if there is a
problem.
1. Check that the warning lamps and meters
are as follows:
¡
Are all the warning lamps off?
¡
Is the water temperature gauge’s needle
within the green range?
2. Check that there are no irregularities in the
exhaust color, sound and vibrations.
: Release : Lock on
3. Set the safety lock lever to the locked
position and check that the offset pedal,
operating and travel levers are locked.
4. Perform the inspection operations
described below and check that the
bucket, arm and boom do not touch the
cab when the boom or bucket is moved
near the cab and stops automatically.
G4D002
1
L2D009
2 3
L2D010
S2B015
(1)Offset the boom to the front of the
operator’s seat and move the boom near
the cab.
Offset the boom to the right and move
the bucket near the cab.
(2)Offset the boom fully to the right and
check that it can be set to the maximum
rear inclination.
(3)Offset to the left in the posture in (2)
above.
Operation when the boom has stopped
automatically
1
If the boom has stopped while rising:
Operate the boom downward.
2
If the boom has stopped while offsetting
to the left:
1. Operate the boom downward to move
it outside the automatic stop range.
2. Offset to the left.
Offsetting to the right is possible
regardless of the boom’s posture.