![background image](http://html1.mh-extra.com/html/takeuchi/tb014/tb014_operators-manual_3334863203.webp)
201
OPTIONS
Radio (for EU)
To cancel the beep tones ............. 1, 7, 8
The unit emits a beep tone to confirm that a
function button has been pressed. To cancel
the function, follow the procedures below.
1
Turn off the power by depressing the ON/
OFF button
1
.
2
With ACC on, press the ATP button
7
and the preset button 6
8
simultaneously
until the display lights. The beep tones
are cancelled and
boF
F
is displayed.
3
To turn the beep tones on again, repeat
steps
1
and
2
and
b-on
is displayed.
Tape operation
Selecting tape mode
Insert a cassette into the tape slot
1
and
the tape player will start.
Switching the tape direction ............ 2, 3
Press BUTTONS
2
and
3
simultaneously.
¡
When the tape reaches the end of one
side, the unit will automatically switch to
the opposite side of the tape.
Fast forward and rewind ................... 2, 3
Press button
2
to fast-forward; press button
3
to rewind the tape. To stop fast forwarding
or rewinding, lightly press the opposite button
2
or
3
to return to the play mode.
During fast forward and rewind, the radio
monitor is activated. The unit receives the
station selected last.
Ejecting the tape ................................... 4
Press the EJECT button
4
to eject a tape.
The system will return to the audio source
selected last.
Radio operation
Selecting radio mode
Each time the BAND button is pressed, the
selected band changes as shown below.
Radio tuning .......................................... 2
¡
Automatic tuning
Press the TUNE/SEEK
+
or
-
button
2
for more than 2 seconds.
When the button is released, the system
will start automatic tuning and stop at the
next receivable station.
¡
Manual tuning
To select higher frequency stations, press
the
+
button for less than 0.5 seconds.
To select lower frequency stations, press
the
-
button for less than 0.5 seconds.
To quickly scan up or down in frequency,
press and hold the
+
or
-
button.
Release the button when the display
approaches the desired frequency, then
press and release the button repeatedly
until the desired frequency is displayed.
A flashing decimal point in the frequency
display indicates that the system is
receiving a station 50 kHz higher than the
displayed frequency.
→
FM1
→
FM2
→
MW
+
C4C031
2
5
DIR
ATP
TUNE/SEEK
CLOCK
1
2
3
4
5
6
P SCAN
ー
.
B A N D
3
6
1
4
+
C4C032
1
DIR
ATP
TUNE/SEEK
CLOCK
1
2
3
4
5
6
P SCAN
ー
.
B A N D
3
4
2