TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 201 / 240

Specifications
201
Constant Current Characteristics
Specification/Models 30-200 30-400 60-100 60-200 120-50 120-100
Range
0.0A -
210.0A
0.0A -
420.0A
0.0A -
105.0A
0.0A -
210.0A
0.00A -
52.50A
0.0A -
105.0A
Accuracy *12
±(0.5%+0.1A) of set
value
±(0.5%+0.2A) of set
value
±(0.5%+0.05A) of set
value
±(0.5%+0.1A) of set
value
±(0.5%+25mA) of
set value
（ 0.5%+50mA ） of
set value
Resolution 0.1A 10mA 100mA
Load Regulation *10
Below 0.05% + (0.01% of maximum output current)
Line Regulation *5
Below 0.05% + (0.005% of maximum output current)
Ripple (Effective Value)
*6
Below
200mArms
Below
400mArms
Below
100mArms
Below
200mArms
Below
50mArms
Below
100mArms
Temperature Coefficient
(Typical Value)
±200ppm/
℃
Specification/Models
400-15 400-30 500-12 500-24 1000-6 1000-12
Range
0.00A -
15.75A
0.00A -
31.50A
0.00A -
12.60A
0.00A -
25.20A
0.000A -
6.300A
0.00A -
12.60A
Accuracy *12
±(0.5%+10mA) of
set value
（ 0.5%+20mA ） of set
value
±(0.5%+5mA) of
set value
（ 0.5%+10mA ） of set
value
±(0.5%+3mA) of
set value
（ 0.5%+6mA ） of
set value
Resolution
10mA 100mA 10mA 1mA 10mA
Load Regulation *10
Below 0.05% + (0.03% of maximum output current)
Line Regulation *5
Below 0.05% + (0.005% of maximum output current)
Ripple (Effective Value)
*6
Below
15mA
Below
30mA
Below
10mA
Below
20mA
Below
5mA
Below
10mA
Temperature Coefficient
(Typical Value)
±200ppm/
℃
Note: *4: Measurement at sensing point for 0~100% change in rated load current (Static Load Change)
*5: For ± 10% change in input voltage (Static input Change)
*6: At measurement frequency band of 20Hz~1MHz (Resistance Loaded)
*7: Measured with oscilloscope at measurement frequency band of 20Hz~20MHz
*8: Recovery time within 0.1%+10mV of rated output voltage for 50% to 100% abrupt change in rated load current (Dynamic
Load Change)
*9: Time in which set voltage error is reached within 1% due to setting changes via panel operation or communication control or
external analog control.
*10: Current change value at the rated output current when load resistance is changed until resistance value outputs 0~rated
power (Static Load Change)
*11: At output open-circuit and environmental temperature 23

C
± 5

C
*12: At output short-circuit and environmental temperature 23

C
± 5

C