TAKASAGO HX-S-01000-12G2, Instruction Manual

Page: 157 / 240

Controlling with External Analog & Contact Signals
157
Analog Output Monitor
*This function can not use 1000V type.
This can produce the DC voltage, which is proportional to the output voltage and output current.
Use when wishing to surveillance the output with an external meter or recorder.
Outputs a "0~10V" DC for output voltage/currents of "0 to rated output".
Please use an input impedance of a 10kΩ or more for the external meter.
Output Voltage Monitor
The accuracy for the output voltage monitor is 0.5% ± 10mV
Connecting
Connect the meter or the recorder between No. 1 and 14 of the external control connector (accessory).
Output Current Monitor
The accuracy for the output current monitor is 1.0% ± 10mV
Connecting
Connect the meter or the recorder between No. 2 and 15 of the external control connector (accessory).
External Control Connector
1
Twisted-Pair Wire
14
V
-
+
External Control Connector
2
Twisted-Pair Wire
15
V
-
+
 Control Common (No. 14 pin) is internally connected to the minus side of the output
terminal.
 Isolation for the wire connecting to the external control should be more than the
relative ground voltage of this product.
Otherwise, the user may receive electric shock.

！
CAUTION
 Output current wave forms cannot be observed by the current monitor.
 Isolation for the wire connecting to the external control should be more than the relative ground
voltage of this product.
Otherwise, the user may receive electric shock.
 Control Common (No. 15 pin) is internally connected to the minus side of the output terminal.
！
CAUTION