20
Optional Items
1. TM-RE10 Temperature Remote Controller
The TM-RE10
Temperature Remote
Controller has two
functions, it allows the
output temperature
from the T-M1 to be
adjusted within the
range of 95 °F to 167 °F, and it also works as a
diagnostic tool that will give a concise error code
whenever there is a problem with the unit. The
temperature options are 95°F, 100°F, 102°F,
104°F, 106°F, 108°F, 109°F, 111°F, 113°F,
115°F, 117°F, 122°F, 131°F, 140°F, 158°F,
167°F, and 176°F for 180°F. See the trouble
shooting section for information on possible error
codes.
3. TK-TV03 Vent Damper
The TK-TV03 Vent
Damper prevents the
backflow of air through
the exhaust vent. This is
CSA approved part of
the unit. This helps
prevent harmful exhaust
gases from entering the home, as well as helping
to prevent the units from freezing in areas where
cold air can be blown into the exhaust system.
Install vent damper according to manufacturer’s
installation instruction, and any applicable codes.
2. TK-TV01 Vent Terminator
This terminator can be used
where a T-M1 is going to be
vented out through a wall. This
is a CSA approved part of the
unit. Connect a Category III
Stainless vent pipe from the
top of the unit to the backside
of this terminator to exhaust
flue gases through the wall without a thimble.
Install vent terminator in accordance with
manufacturer’s installation instructions and any
applicable local codes.
4. TM-TV06 Vent Cap
The TM-TV06
Vent Cap is for
outdoor
installation with
the T-M1 water
heater. The cap is installed on the top of the unit,
instead of connecting an exhaust vent. The cap
will prevent any debris that might be in the
environment from entering the unit and causing
damage or a fire hazard, as well as preventing
rain or other weather from entering the unit.
