- 24 -
Optional Items
1. TM-RE10 Temperature Remote Controller
The TM-RE10
Temperature Remote
Controller has two
functions. It allows the
output temperature
from the T-H1 to be
adjusted within the
range of 99°F to 182°F, and it also works as a
diagnostic tool that will give a concise error code
whenever there is a problem with the unit. The
temperature options are 99°F, 100°F, 102°F,
104°F, 106°F, 108°F, 109°F, 111°F, 113°F,
115°F, 117°F, 122°F, 131°F, 140°F, 158°F,
167°F, and 182°F. See the trouble shooting
section for information on possible error codes.
2. TK-TV01 Vent Terminator
This terminator can be used
where a T-H1 is going to be
vented out through a wall. This
is a CSA tested Takagi
component. Connect the
Category III stainless steel vent
pipe from the top of the unit to
the backside of this terminator to exhaust flue
gases through the wall without a thimble. Install
this vent terminator in accordance with Takagi’s
installation instructions and any applicable codes.
3. TK-TV03 Vent Damper
The TK-TV03 Vent
Damper prevents the
backflow of air through
the exhaust vent. This is
a CSA tested Takagi
component. This helps
prevent harmful exhaust
gases from entering the home, as well as helping
to prevent the units from freezing in areas where
cold air can be blown or drawn into the exhaust
system. Install this vent damper in accordance
with Takagi’s installation instructions and any
applicable codes.
4. TK-TV05 Direct Vent Terminator
This terminator can be used
where a T-H1 is going to be
vented out through a wall.
This is a CSA tested Takagi
component. Connect the
Category III stainless steel
vent pipe from the top of the
unit to the backside of this
terminator to exhaust flue gases through the wall
without a thimble. Install this vent terminator in
accordance with Takagi’s installation instructions
and any applicable codes.
Exhaust vent pipe use Cat III 4” and intake air 3”
5. TK-TV07 Direct Vent Conversion Kit
This kit can be used convert
the T-H1 from a conventional
vent system to a direct vent
(or sealed combustion)
system. This is a CSA tested
Takagi conversion kit. Install
this conversion kit in accordance with Takagi’s
installation instructions and any applicable codes.
6. TK-TV08 Vent Cap
The TK-TV08 Vent Cap
is used when the T-H1
appliance is to be
installed outdoors. The
cap is installed over the
flue collar, instead of connecting an exhaust vent.
The cap will prevent any debris that from entering
the unit and causing a fire hazard or damage, as
well as preventing rain or snow from entering the
unit.
