- 16 -
Check the signal loop
When signal loop is acceptable, Beeping sound is emitted.
Adjust output power
When output is adjusted
*When the Receiver indicates “ OVER” , Press
key.
Þ
Reduce output.
*When locating a long-distance line or deeper depth than 3m / 16ft., Press
key.
Þ
Increase output.
Check the voltage when connecting clip to Power line.
- When voltage is greater than 20 volts, voltage is displayed.
- When voltage is greater than 25 volts, Alarm sounds.
Note: 512Hz output is cut off automatically.
Press
ADJUST
key.
*Transmitter will beep for 30 seconds.
*Sound stops when Press ADJUST key.
*Sound setting is [b-0].
Þ
Beeping sound off.
Automatically adjust power
Direct Connection
GOOD
SIGNAL LOOP
*When “GOOD SIGNAL LOOP” isn't indicated after pressing ADJUST.
Þ
Clean off the connected part if rusted or painted or move ground stake.
Note:
Beeping sound is emitted
after output is adjusted when the resistance value of the cable is high.
ELECTRIC SHOCK
Death or serious injury will result. 250 Volts maximum across
clips. Use protective equipment.
PEEEEEE!!!!
AC VOLTAGE
*Alarm stops when Press ADJUST key.
*Sound setting is [b-0].
Þ
Alarm off.
。
P P P P ….
DANGER
