TAJIMA TLMX Series, User Manual

Page: 223 / 318

To return the frame to the design start position
208
Chapter 7
RR05
4-2. To return the frame to the design start position automatically (Auto Origin Return)
This is the setting to return the frame to the design start position automatically after embroidery is finished.
When Automatic offset is set, the frame will return to an offset start position.( → p.209)
4-2-1. Explanation on the screen
4-2-2.
How to operate
The following is an example of setting Automatic origin return.
(1) To open screen
(2) To make auto origin return effective
After embroidery is finished, do not put your hands etc. on the table. Moving frame could
injure you.
NO
4 Automatic Origin Return Auto Origin Return
YES: To set
NO: Not to set
!
CAUTION
4 Automatic Origin Return
NO
YES