TAJIMA TLMX Series, User Manual

Page: 224 / 318

To move the frame to the position registered
209
Chapter 7
1
2
3
4
5
6
7
8
9
10
11
12
SQ01
5.
To move the frame to the position registered
5-1. To move the frame automatically at the start and the end of embroidery
(Automatic Offset)
This is the setting to move the frame automatically so that replacement of the frame and the fabric to be
stretched can be performed easily. Perform this setting after data set. Setting contents here will be added in
a design. So, when you embroider this design next time, setting again will be unnecessary.
The following is an example of movement when the setting of "Auto Color Change (AC) / Auto Start (AS)",
"Automatic Thread Trimming" is "YES".
[In case of FM head]
(1)
At the start of embroidery, the frame will pass through the offset middle position [B] from the offset start
position [A] by the bar switch or start switch and move to the design start position [C], then the embroidery
will start.
(2) At the end of embroidery, the frame will pass through the offset middle position [B] from the design end
point [D] and move to the offset start position [A].
[In case of LM head]
(1)
At the start of embroidery, the frame will pass through the offset middle position [B] from the offset start
position [A] by the bar switch or the start switch operation (hereafter, the switch operation) and move to
the design start position [C].
(2)
The embroidery will start by the switch operation.
(3)
At the end of embroidery, the machine stops. The frame will pass through the offset middle position [B]
from the design end point [D] by the switch operation and move to the offset start position [A].
[A]
[C]
[B]
[B]
Embroidery starts Completion of embroidery
[D]
[A]