TAJIMA TEMX-C Series, User Manual

Page: 73 / 242

To decide the design start position
60
Chapter 4
RR07
5-4.
To check if the design fits in an embroidery space (Trace)
Since the frame moves according to the size of the frame, you can check if the design fits in the embroidery
space or not.
5-4-1.
Explanation on the screen
5-4-2.
How to operate
The following is an example when executing trace.
(1)
To open screen
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
1
2
3
4
5
6
7
Start position of design
The number in the left picture indicates the path of the frame. After
completion of trace, embroidering from that position is possible.
When repeat is set
The machine will trace the whole designs after tracing the first
design.
When automatic offset is set
The machine traces according to setting.
D1
/Low/High
Needle position
15
1 Trace
Speed of frame travel
Low: slow
High: fast
-: Not to execute
Current needle bar No.
The frame moves on the basis of this needle bar.
!
CAUTION
1 Trace