TAJIMA TCMX 601, User Manual

Page: 53 / 130

5-12
Functions that are frequently used
10.
Automatic offset
When embroidery is finished, this function makes the frame move
automatically to the front (the position, as you desire).
1.
To call the screen......................................................
2.
To set ........................................................................
1.
Offset middle position (OF1)
The distance from the current frame position
The frame will move.
When not setting OF1, press [SET] to proceed ton the
following operation.
It is not possible to use the jog dial/jog shuttle.
2.
Offset start position (OF2).................................................End
The frame will move.
Switching the screen
Main screen..................
Other setting • operation
CAUTION
Since the frame moves at setting, pay enough attention
to the surrounding safety, and then start operation.
At the end of embroidery, do not put your hands etc. on
the machine table. Since the frame moves, you could be
injured.
Automatic offset must be set after inputting data (The
design of which data has been set is the target). If data of
another design is set, the set value will be deleted.
Outline of automatic offset: p.5-13
List screen List screen
Press B.
B
5 Automatic Offset
or
Offset start position (OF2)
Offset middle position (OF1)
Offset middle position (OF1) and offset start position
(OF2) are displayed by a distance from the current
frame position.
OF2
OF1
Design start position
Design end
position
Previous setting
5 Automatic Offset
!
Example:X:50,Y:150
OF1 X
Y
50
150
Example:X:20,Y:120
OF2 X
Y
20
250
E
A D2 F1 F6
JZ07