TAJIMA TCMX 601, User Manual

Page: 47 / 130

5-6
Functions that are frequently used
6.
Repeat
This function embroiders design repeatedly.
1.
To call the screen......................................................
2.
To set ........................................................................
1.
Repeat mode
When not changing, press [SET] to advance the cursor.
2.
The number of repeats (crosswise)
3.
Design interval (crosswise)
The frame will move in the crosswise direction.
4.
The number of repeats (lengthwise)
5.
Design interval (lengthwise)
The frame will move in the lengthwise direction.
CAUTION
Since the frame moves at setting, pay enough attention
to the surrounding safety, and then start operation.
Repeat setting must be performed after inputting data
(The design of which data has been set is the target).
It is not possible to set repeat in the middle of embroi-
dery.
Outline of repeat: p.5-7
!
List screen List screen
Press B.
B
4 Repeat
or
Repeat mode
1
(Usual repeat), (X-axis mirror image repeat)
(Y-axis mirror image repeat) (180 degrees rotated
repeat)
(To move to the next design after thread trimming)
(To move to the next design by stitching)
1
pp pb
pq pd
2
Trim
Stitch
The number of
Design interval
The number of
Design interval
Priority
Design interval mode
4 Repeat
2
repeats (crosswise)
(crosswise)
repeats (lengthwise)
(lengthwise)
pp
Example: Usual repeat
10
Example:10
150
Example: 150 (mm)
10
Example:10
200
Example:200(mm)
JZ07