Tait TP9160, User Manual

Page: 21 / 108

Fitting a speaker microphone 21
B
e
for
e
fir
st use
of your r
a
dio
Fitting a speaker microphone
Speaker microphones are attached to the radio via an
accessory connector. The standard speaker
microphones do not have an antenna connector,
whereas the RF speaker microphone has a connector for
the radio antenna.
Removing the protective cover
Before fitting the speaker microphone, you may need to
remove the radio’s protective cover. This cover is located
above the battery on the rear of the radio.
1 Insert a coin, or other suitably shaped object, into
the slot of the protective cover. Twist the coin
clockwise from the locked to unlocked position.
2 Remove the cover and store in a safe place.
Attaching the accessory connector
Once you have removed the protective cover, you can fit
the speaker microphone accessory connector to the
back of the radio.
1 Push and hold the metal clip to release the lever.
2 Rotate the lever clockwise to an upright position.
3 Insert the white locking clip into the matching hole
at the rear of the radio.
4 Rotate the lever counterclockwise until you hear
it click.
5 Check that the accessory connector is firmly locked
into place.
metal clip
lever
insert the white locking
clip into this hole