2
TMAA05-05/TMAA05-06 GPS Receivers
© Tait Limited June 2013
Ø2.36 in. (60 mm)
0.79
in.
(20
mm)
0.79
in.
(20
mm)
Ø3/4 in.
(19 mm)
mounting
surface
4 For through-hole mounting the TMAA05-
06, drill a 3/4 inch (19mm) diameter hole
through the mounting surface, remove the
two nuts and the washer from the GPS
receiver and pass the cable through the
hole. The rubber ring at the bottom of the
GPS receiver provides a seal against the
mounting surface. Pass the cable through
the washer and two nuts and secure the
GPS receiver to the mounting surface.
5 Run the GPS receiver cable to the adapter
cable, and connect using the mini-DIN
plug and socket. For the correct orientation, line up the arrow with the dash symbol.
6 (Optional) Place one half of the connector cover on one side of the connected mini-
DIN plug and socket. Place the other half of the connector cover on the other side
(making sure you orient it the correct way so the notches line up), and snap the two
halves in place. If additional retention is required, fasten cable ties or similar through
the square holes on each side of the cover.
To remove an installed connector cover so it is reusable, use a small flat-head screwdriver
to release one clip, and hold so that clip remains open while releasing the other clip at the
same end. Use the same technique to release the clips at the other end, and then ease the
two halves of the cover apart.
7 Tie up any unused cables.
Programming Radios
For information about programming the radio for use with the GPS receiver refer to the
Help of the programming application. For information on GPS and AVL (automatic vehicle
location) applications, contact your radio provider.
More Information
Refer to your radio provider for more information about these products.
