TM9456 Dual-Radio Installation and Programming Guide
Installing a Dual-Radio System
32
© Tait Limited
July 2016
Assembling the
Control Head
Interface
The following steps show how to connect the control head remote interface
to the control head.
1.
Undo the two Torx T-
20 screws on the
adaptor flange of the
control head, and
remove the adaptor
flange.
2.
Keep the two screws
for step 6.
3.
Unplug the control-
head loom.
4.
The adaptor flange and
control-head loom are
not used for the remote
control-head
installation.
Notice
You can change the control head orientation by changing the
control-head loom to the opposite connector. For more information,
refer to the remote control-head installation instructions (IPN 402-
00020-xx, available from
).
5.
Plug the control-head
interface loom into the
connector on the
control head.
6.
Use the two Torx T-20
screws from the first
step to fit the control-
head remote interface
to the control head.
