Tait TB9100, Installation And Operation Manual

Page: 80 / 144

80 Replacing Modules TB9100 Installation and Operation Manual
© Tait Electronics Limited May 2006
7.5 Replacing the Power Amplifier
Important
Before removing a PA, disconnect the DC input and RF
input first, followed by the RF output (and DC output on
the 12V PA). After refitting the PA, reconnect the RF out-
put (and DC output on the 12 V PA) first, followed by the
RF input, and then the DC input.
Removal
1. If you have not already done so, carry out the instructions in
“Preliminary Disassembly” on page 75 . If necessary, remove the
control panel, as described in “Replacing the Control Panel” on
page 77 .
2. At the front of the PA, unplug the DC input cable (DC output cable
on the 12 V PA)
b
and the RF input cable
c
, and move both cables
to one side. Unplug both ends of the system control bus loom
d
and
remove it.
3. At the rear of the PA, unplug the RF output cable. 12V PA only:
also unplug the battery supply lead.
4. Loosen the screw securing the retaining clamp(s)
e
and rotate the
clamp(s) through 90° to clear the module.
5. Slide the PA out of the subrack, taking care not to damage any of the
cables.
Refitting
1. Slide the replacement PA into the subrack and secure it with the
retaining clamp(s).
2. At the rear of the PA, connect the RF output cable. 12V PA only:
also connect the battery supply lead.
3. At the front of the PA, connect the RF input cable, followed by the
DC input cable (DC output cable on the 12V PA).
b
e
c b
d
d e c e