Tait TB9100, Installation And Operation Manual

Page: 77 / 144

TB9100 Installation and Operation Manual Replacing Modules 77
© Tait Electronics Limited May 2006
Remove the Front
Panel
1. Undo the fastener at each end of the front panel
b
with a quarter
turn anti-clockwise.
2. While supporting the left end of the front panel, place your fingers in
the recess provided on the left side of the control panel opening
c
and pull the right end of the front panel away from the subrack. You
will need to overcome the resistance of the spring clip securing the
front panel to the control panel.
7.3 Replacing the Control Panel
Removal
1. If you have not already done so, carry out the instructions in
“Preliminary Disassembly” on page 75 .
2. Undo the retaining screw
b
. Note that the screw stays attached to the
control panel.
3. Pull the bottom of the control panel away from the subrack
c
to
disconnect the D-range socket on the back of the panel from the plug
d
on the subrack.
b
locked unlocked
c